Manual of Forming and Cutting Foot Integrated Machine
(Vertical JT80-40 type)
1、 Preface
JT80-40 molding all-in-one machine; It is a self-developed equipment by our company for pulling and shearing magnetic ring inductor pins; This model is designed specifically for large magnetic rings, anisotropic magnetic rings, and magnetic ring inductors with a wire diameter of 1.0MM-2.5MM. It provides cutting and shaping work, and the entire process is completed in 0.5 seconds. A circular inductor pin cutting and shaping equipment with high processing efficiency, good product quality, and reduced labor costs. Due to its stable equipment and wide adaptability, it is loved by the circular inductor processing industry.
2、 Main features
◆: Overall compact and compact, the panel is made of top-notch steel material, with a surface electroplated and hardened treatment, and the design surface is flat; Designed in accordance with ergonomics, hands will not feel tired after prolonged operation; More aesthetically pleasing appearance;
◆: The wire outlet is made of 16mm thick steel protective plate. Protect the machine's cutting blades from injuring hands. Safer operation;
◆: Adopting a large inner diameter cylinder, stable operation, and strong cutting force.
◆: Wide compatibility, the small ring can be directly formed, and can be used to shape and repair the upper bottom plate and soldered products. Directly replace the old molding foot clipper.
◆: Using a regular 0.8mpa air compressor air source. 220V power input.
3、 Installation instructions
1. Install the filter regulator vertically, with the left side connected to the air compressor and the right side connected to the machine, with a pressure of 0.4-0.45MPA (it has been adjusted at the factory and cannot exceed 0.5MPA);
2. Observe whether there is water in the jar every day, drain the water from the top and bottom of the jar, and push out the water from the top pin to prevent water from entering the solenoid valve and damaging the components.
Attention: The stabilizing filter should not be connected in reverse. It is required to be fixed and not adjustable. Check the moisture content every day
4、 Replace the fixture
1: First, turn off the power. Loosen the bolts on the fixture cover plate, take out the fixture cover plate, and then install the entire set of fixtures in sequence; Be sure to turn off the power before operating
Attention: After covering the fixture cover, put on the screws of the fixture cover, twist the screws in place by hand without tightening them, and then turn on the power switch. Step on the foot switch and tighten the screws. Twisting too tightly may cause deformation of the cover plate, affecting the normal operation of the fixture
6、 Regular maintenance
This equipment must pay attention to maintenance, oiling, and lubricating the moving parts. Maintain and oil at least once a week. Open the cover plate of the fixture and apply oil to the sliding block position.
Attachment: One filter regulator, one power cord, one foot switch, and one 3MM hex wrench. Attention: The air source filter regulator must be installed within a distance of 2 meters from this equipment. Install vertically facing the pressure gauge bottle downwards. Connect the air compressor on the left and the equipment on the right. Adjust the pressure to around 0.4MPA, not exceeding 0.5MPA (already set at the factory), and pay attention to regularly draining the water in the tank.